Installation And Power Connection; Before Installation - janitza SVG Series User Manual

SVG 50/100
5.

Installation and power connection

All SVG modules have identical current and signal interfaces.
The description of the installation is provided based on the example of the
filter SVG-LCD W 400 V 50 kvar.
5.1

Before installation

Take note of the safety information (chapter 2)!
Check the line marking of the input terminals and the line marking of the external current
transformer (CT). Check the wire diameter and the phase sequence of the input current for
correctness. The power data of the input line can be found in the technical specifications in
appendix 3.
Since the power and signal interfaces of the SVG modules are identical, the description
here only covers the installation and electrical connection of one of the modules with dis-
play/without display of the same capacity level.
As shown in Figure 3-1, the rack module must be installed in the switchboard cabinet.
Observe the factory specified drilled holes as marked in Figure 3-1 for the installation of a
single module.
The wall module must be fastened to a solid wal whereby the specified size and location of
the drilled holes for the installation are shown in Figure 3-2.
Connection options:
Network system
Rack module with LCD display
Wall module with LCD display
Rack module without display
Material damage due to disregard of the mounting instructions!
Disregard of the installation instructions can damage or destroy your
device and its component.
Therefore please abide by the following:
• Maintain the minimum distances during installation!
• Provide adequate air circulation in the installation environment and cool-
ing, as needed, when the ambient temperatures are high!
• Ground current-conducting switchboards!
• Follow the installation instructions in the documents that belong to the
device and its components!
18
NOTE
3 phase 3 phase with N-conductor
X
X
X
ATTENTION
X
X
X