Advertisement
CHALLENGER
Wiring Harness
Kit Part Number: CCRKIT38
Parts List
-
Indirect Circulator Wire Harness
-
Duplex Electrical Connector
Recommended tools:
-
Pliers
-
Phillips Screw Driver
-
Small Flat Head Screwdriver
W RNING
Indicates a potentially hazardous situation
which, if ignored, can result in serious
injury or substantial property damage.
W RNING
For your safety, turn off electrical power
supply at service panel before proceeding to
avoid possible electrical shock hazard.
Failure to do so can cause severe personal
injury or death.
Indirect Circulator
Kit
NOTI E
Indicates special instructions on installa-
tion, operation or maintenance, which are
important to equipment but not related to
personal injury hazards.
W RNING
Failure to follow instructions below can result
in severe personal injury or damage if ignored.
•
Instructions are for a qualified installer/ ser-
vice technician.
•
Read all instructions before proceeding.
•
Follow instructions in proper order.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for TriangleTube CHALLENGER CCRKIT38
Summary of Contents for TriangleTube CHALLENGER CCRKIT38
- Page 1 Indirect Circulator CHALLENGER Wiring Harness Kit Part Number: CCRKIT38 Parts List Indirect Circulator Wire Harness Duplex Electrical Connector Recommended tools: Pliers Phillips Screw Driver Small Flat Head Screwdriver W RNING NOTI E Indicates a potentially hazardous situation Indicates special instructions on installa- which, if ignored, can result in serious tion, operation or maintenance, which are injury or substantial property damage.
- Page 2 Indirect Circulator CHALLENGER Wiring Harness Harness Installation Instructions should be routed to the line voltage terminal strip area. See Fig. 3. 1. Turn the power to the unit OFF by disconnect- ing the main power source. W RNING ELECTRICAL SHOCK HAZARD. ON/OFF switch of the boiler does not discon- nect electrical power to the module.
- Page 3 Indirect Circulator CHALLENGER Wiring Harness 9. Connect the wiring from the indirect circulator to the indirect circulator wiring harness by lift- ing up the orange lever on the splicing connec- tors and inserting the stripped wire. Push down on the orange lever and verify that the wire is held in the connector.
- Page 4 Indirect Circulator CHALLENGER Wiring Harness Setting the Appliance Parameters NOTI E 1. Press the “ ” button at the display panel for approximately 2 to 3 seconds until the main dis- If the reset button is not pressed within 30 play on the left begins to flash.
Need help?
Do you have a question about the CHALLENGER CCRKIT38 and is the answer not in the manual?
Questions and answers