Handicare Combi User Manual page 5

To ensure proper alignment of the castors, the snaplock pin will not fit into the tubes if the holes are mis-aligned.
REAR wheels: Remove the cover plate (3 on drawing) on the outside of the wheel. Unscrew the locking nut on the back
of the wheel and remove the wheel axle. Choose the desired height position, replace the wheel axle, and re-insert and
tighten the locking nut. Be certain that both the bolt and the nut are tightened. Replace the cover plate.
REAR wheel brakes: Loosen the screw (4 on the drawing) and move either forwards or backwards to suit the height of
the wheels. The brake pad should be positioned approximately 1 cm/ 0.40 inches from the tire in the unlocked position.
After adjustment, re-tighten the screw.
Bedpan / Bucket frame – see figure 2:
The bedpan / bucket frame can be used in
combination with a keyhole shaped or round bucket.
To assemble: The two end pieces (B, on the drawing)
rest on the rear of the seat frame.
For keyhole shape bucket, insert the two front rods (A)
into the inner holes (C). For all other bucket shapes use
the outer holes (D). If no bucket or bedpan is being used,
the frame may be detached so the chair fits easily over a toilet.
Height Adjustment - see figure 3:
By repositioning the snaplocks on the chair legs, the Combi self-
propelled may be adjusted to 6 different heights.
To adjust the height of the chair - see figure 3:
1. Remove snaplock
2. Select one of the 6 positions
3. Reinsert snaplock.
Repeat for all 4 legs (2 front castors and 2 rear anti-tip feet).
IMPORTANT: Check that all four legs are the same height and that all
of the snaplocks are inserted correctly into the frame before use.
Adjusting the height of the rear wheels - see figure 1:
1. Remove the cover plate (3 on drawing) on the outside of the wheel.
2. Unscrew the locking nut on the back of the wheel and remove the
wheel axle.
3. Choose the desired height position (3 choices)
4. Replace the wheel axle, and re-insert and tighten the locking nut.
Be certain that both the bolt and the nut are tightened.
5. Replace the cover plate.
Adjust the rear wheel brakes by loosening the screw (4 on the drawing)
and moving it either forwards or backwards to suit the height of the
wheels. The brake pad is positioned approximately 1 cm/ 0.40 inches
from the tire in the unlocked position. After adjustment, retighten the
screw.
Figure 2
1
3
2
Figure 3
Snaplock
5