Digital Watchdog STAR-LIGHT Universal HD over Coax DWC-V6263TIR Quick Start Manual page 2

STEP 3 – CHANGING THE SIGNAL IN
THE CAMERA
1. The camera supports HD-Analog, HD-CVI and HD-TVI signals. To
switch between the signals:
a. Remove the camera's dome to access the joystick and OSD
control on the base of the camera.
b. Use the OSD Switch to switch the camera's signal.
- To switch the camera to HD-TVI mode, press OSD joystick to the
left for 5 seconds.
- To switch the camera to HD-Analog mode, press OSD joystick to
the right for 5 seconds.
- To switch the camera to CVBS mode, press OSD joystick
up for 5 seconds.
- To switch the camera to HD- CVI mode, press OSD joystick
down for 5 seconds.
STEP 4 – INSTALLING THE CAMERA
1. Once all cables have been connected, use the screws included
with the camera to properly mount and secure the camera to the
mounting surface.
2. Adjust the camera's pan, tilt and position to achieve the desired
view. The cameras' max angles are:
Pan: 0° ~ 360°
Tilt: 0° ~ 90°
Rotation: 0° ~ 360°
3. To adjust the camera's focus and zoom:
a. Unlock the zoom or focus screws by rotating them
counter-clockwise.
b. Adjust the zoom and focus screws at the base of the camera
module to achieve a clear image.
c. Tighten the screws and close the front case by rotating it
clock-wise.
4. Once the installation is complete, remove the protective film from
the camera's dome cover.
Test video slot
OSD joystick controller
CVBS(960H)
U
Enter
L R HD-A
HD-TVI
D
HD-CVI
FOCUS
ZOOM
Focus: Far Near
Zoom: Wide Tele
Rev Date: 09/19
Quick Start Guide
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.