Eneo VKC-1360 Installation And Operating Instructions Manual page 34

5) SYNC
INT
L/L
PHASE
6) LANGUAGE
5.8 ADJUST
1) SHARPNESS
2) BLUE
3) RED
5.9 RESET
1) FACTORY
5.10 EXIT
1) EXIT
Select Internal or Line Lock mode.
This mode is necessary for using the internal synchronization.
This mode is necessary for the operation of multi camera because it
synchronizes the camera phase by using the external signal (AC Signal).
Sync phase is adjustable in line lock mode.
You can change the OSD language using the LEFT/RIGHT Setup switch.
Can be adjusted SHARPNESS of outlines. (0~3)
Adjust B-GAIN value. (0~00)
Adjust R-GAIN value. (0~00)
Returns to the level which was set by the manufacturer for
Saves all the setting menus and then exits.
34