Eneo VKC-1360 Installation And Operating Instructions Manual page 29

5.2 LENS (Selection)
This function is used to adjust the brightness of the screen.
. When the SETUP menu is displayed on the screen, please position the arrow to point to
„LENS" by using the UP and DOWN buttons.
. Please select the type of the lens you wish to use by pressing the LEFT or RIGHT button.
NOTE: The brightness of the screen can be adjusted in DC mode.
The brightness can be adjusted within the range of 0 ~ 100.
The optimum level of brightness for the user can be achieved by adjustment.
5.3 EXPOSURE
The EXPOSURE menu is used to set the automatic light control method for this camera.
1) SHUTTER
2) BRIGHTNESS Adjust BRIGHTNESS level (0 ~ 00)
3) AGC
4) SENSE-UP
5) BLC
6) D-WDR
Select the shutter mode.(/60(50), FLK~ /00,000 sec, x ~ x56)
Can be changed while in shutter mode.
Can be adjusted while in manual lens mode.
Auto gain control (OFF / LOW / MIDDLE / HIGH)
In DAY/NIGHT mode AUTO must be switched off.
Use under very low light condition for full colour surveillance.
Select maximum Low-Shutter value. (x ~ x56)
Sharpens subjects with backlight. (OFF / BLC / HBLC)
Digital Wide dynamic range (Xtended Dynamic Range)
OFF / INDOOR / OUTDOOR
9