ToolKitRC M8 Manual page 27

signal value to be output.
When set to Auto 1, 2, 3, the pulse width value of
the output PWM will automatically change at 3
different speeds.
Pulse width can be set from 800 to 2200us The
cycle can be set from 2.5ms (400Hz) to 50.0ms
(20Hz).
Rotate the encoder disk on the output main
interface to move the cursor to the [PPM] item, press
[OK] to enter the PPM output interface as shown
below.
Rotate the encoder disk to move the cursor to
the value that needs to be modified. Press [OK] to
modify the output pulse width value of this channel.
Rotate the encoder disk on the output main
interface to move the cursor to the [xBus] item, press
[OK] to enter the compatible signal output of SBus,
Dbus, etc., rotate the encoder disk, and switch the 16
channel value and status bit. The display interface is
as shown below (9-16 channel and status display
27
@ ToolkitRC 2018