Replacing The Power Cable - WAGNER Super Finish 33 PLUS Service Manual

Super Finish 33 PLUS/PRO • Nespray Pro
3.5

REPLACING THE POWER CABLE

This may only be carried out by a skilled elec-
trician. No liability is assumed for incorrect in-
stallation. Switch the unit off.
Before all repair work: Unplug the power
plug from the outlet.
Do not dismantle the sealed pressure control
valve (1) so as to ensure that the pressure set-
ting is retained.
To remove the pump, move it to an upright
position. Open the oil lock screw (A) to re-
lease any excess pressure that has built up in
the hydraulic oil housing.
1. Completely unscrew the pressure control valve (1) (span-
ner width 17 mm).
2. Remove the front cover (2) by loosening the 5 screws
using an Allen key (SW 3).
The fixed part of the cable threaded joint (3)
is glued to replace the counter-holding.
3. Loosen the cable threaded joint (3).
4. Loosen the wires in the mains terminal (4).
5. Replace the unit connecting line.
(only an approved power cable with the designation H07-
RNF with a splash-proof plug may be used).
Version SF 33 PLUS
4
2
6. Connect the green/yellow wire to the contact with the PE
sign (see circuit diagram).
7. Remount the covers carefully (do not squeeze any cables!)
8. Replace the pressure control valve in the housing and
screw into position.
Version SF 33 Pro
3
1
4
GB
A
3
9