Repairs At The Unit; Inlet Valve Pusher; Inlet Valve - WAGNER Super Finish 33 PLUS Service Manual

Super Finish 33 PLUS/PRO • Nespray Pro
3

REPAIRS AT THE UNIT

Switch the unit off.
Before all repair work: Unplug the power
plug from the outlet.
3.1

INLET VALVE PUSHER

1. Use a 17 mm spanner to screw out the inlet valve button.
2. Replace the wiper (1) and O-ring (2).
1
2
3.2

INLET VALVE

1. Place the enclosed 30 mm wrench on the trigger housing
(1).
2. Loosen the trigger housing (1) with light blows of a ham-
mer on the end of the wrench.
3. Screw out the trigger housing with the inlet valve (2) from
the paint section.
4. Pull of the clasp (3) using the enclosed screwdriver.
5. Place the enclosed 30 mm wrench on the inlet valve (2).
Turn out the inlet valve carefully.
6. Clean the valve seat (4) with a cleaning agent and brush
(ensure that no brush hairs are left behind).
7. Clean the seals (5, 6) and check for damage. Replace, if
necessary.
8. Check all the valve parts for damage. In case of visible
wear replace the inlet valve.
3
4
Installation
Valve lift (*) has to be 2.4 mm (± 0.05 mm).
1. Insert the inlet valve (2) into the trigger housing (1) and
secure with the clasp (3). Ensure that the (black) seal (5) is
mounted in the trigger housing.
2. Screw the unit from the trigger housing and the inlet
valve into the paint section. The same (black) seal (6) has
to be mounted in the paint section.
3. Tighten the trigger housing with with a suitable torque
wrench (90 Nm tightening torque).
1
5
*
2
6
GB
7