Topeak NINJA CO2+ User Manual

NINJA CO2 + / NINJA CO2
Tire Lever
NINJA CO2+
HOW TO USE MICRO AIRBOOSTER
Schrader Valve
1
Thread-in CO cartridge.
2
Presta Valve
1
Thread-in CO cartridge.
2
WARNING
• If using the Micro AirBooster inflator continuously, make sure to wait 20 seconds in between cartridges for the
rubber grommet inside the inflation head to return to its original position. Otherwise, a gas leak may occur and
prevent proper inflation.
• Tighten the CO cartridge before using CO
2
may cause injury.
• DO NOT remove CO cartridge if it is still charged with gas. Completely discharge the CO
2
• When opening the CO cartridge, point the inflator head away from yourself and others.
2
• DO NOT use Micro AirBooster Inflator if any part is cracked or broken.
• DO NOT expose the CO cartridge to heat, or store at temperatures above 120˚F (49˚C), or store in enclosed vehicles.
2
• Make sure to wear gloves when inflating to avoid injury.
• The barrel and CO cartridge may become extremely cold/ frosty when the CO
2
• DO NOT try to unscrew the Micro AirBooster inflation head until it has warmed sufficiently to touch.
• Keep out of reach of children.
NINJA CO2
2
Install and thread-in inflation head
to Schrader valve.
2
Przed pompowaniem poluzuj trzpień
wentyla.
inflation function. Failure to do so will cause improper operation and
2
• Accepts all 16g threaded CO
• Recommended to use Topeak 16g threaded CO
• Please read all instructions before first use.
• Periodically check that components are still securely
fastened to your bike.
• Kompatybilne z serią Ninja Cage.
16g Topeak
Threaded CO
Cartridge x 2
3
Start and regulate CO flow by pushing
2
inflation head onto valve stem.
3
Start and regulate CO flow by pushing
2
inflation head onto valve stem.
cartridge before removal.
2
gas is expelled.
2
User's Guide
cartridges.
2
cartridges.
2
Inflation Head
CO Cartridge
2
Engagement
Micro AirBooster
2
NOTE
To avoid possible personal
injury and damage to bike
and /or tool, ensure to
disengage CO inflator
2
properly after use by
unthreading inflation head
in correct direction.
YES
After each inflation, make sure
all CO gas has been discharged
2
by pushing the Micro AirBooster
inflation head several times.
EN
NO