Operating Programme - Riello Gulliver BG1 Installation, Use And Maintenance Instructions

4.10

OPERATING PROGRAMME

4.10.1 NORMAL OPERATION WITH PREHEATING
P
TL
t
2
PH
t
2p
K
MV
M
I
V 1
F
Yellow
LED
Loss of flame during operation (Recycle max. 3 attempts)
MV = stopped
F
LED
Standby time pending an input signal to control box:
t1
reaction time, control box takes no action for time t1.
Extraneous light detected before demand for heat:
t1I
lockout occurs if light persists for time t1l.
Standby time following a demand for heat:
t2
control box takes no action for time t2.
Extraneous light detected during oil preheating or standby:
t2I
lockout occurs if light persists for time t2l.
Max. preheating time:
t2p lockout occurs if thermostat K does not switch within time
t2p, control box takes no action for time t2p.
Pre-purging time:
t3
fan motor starts.
Extraneous light detected during pre-purging:
t3I
immediate lockout.
3399
t
1
t
3
t
4i
t
s
Green Yellow
Green
Yellow Yellow
No signal needs to be received
KEY TO LAY-OUT
D7230
F – Flame detector
I – Ignition transformer
K – Thermostat enabling start-up after
LED – Reset button LED indicating operating
MV – Fan motor
PH – Oil heater
TL – Limit thermostat
V1 – Oil valve 1st stage
t
5i
Green
Yellow
t
4L
.
Lockout
D7243
OPERATING TIMES
t1
Yellow
t1I
t2
t2I
t2p
t3
t3I
Time is expressed in seconds
Safety time: lockout occurs if no flame is detected by the
ts
end of time ts.
Transformer ignition time:
t4i
total ignition time: ts + t5i.
Transformer post-ignition time:
t5i
additional ignition time following ts.
Flame loss during operation:
t4I oil valve drop maximum reaction time, lockout occurs after 3
recycle attempts.
Post-purging time:
t6 additional purging time when heat demand limit thermostat
(TL) opens.
Extraneous light detected during post-purging:
t6I
lockout occurs if light persists for time t6l.
Long pre-purging time:
t7
pre-purging time longer than t3.
10 GB
preheating
status
Red
Green + Yellow slow flashing
Green + Yellow fast flashing
Yellow
Green
Green + Yellow medium flashing
Red + yellow fast flashing
Yellow fast flashing
max 1 ts
max 30 t4i
- 3 t5i
max 30 t4I
max 600 t6
- 15 t6I
max 1 t7
- 5
- 8
- 3
max 1
max 360
max 30
- 120