Hardware Installation - Acksys RailBox Series Quick Installation Manual

1. Plug the antennas in
Plug the antennas of your choice (not included) to the QMA-type connectors.
For single antenna installation, use ANT1 connector. For dual antenna
installation, use ANT1 and ANT2 connectors.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput, and as well as waterproofness.
2. Connect the power supply
See the "specifications" section about the characteristics of the power supply.
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LEDs Power1 and Power2:
Power1 LED is ON if POWER1 power supply or PoE+ source is ON.
-
Power2 LED is ON if POWER2 power supply is ON.
-
The Diag LED stays red for around 40 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
PoE+ models must be exclusively powered by a PoE+ power source (802.3at
type 2 class4) connected to LAN2 connector (using the POWER M12
connector may damage the product).
3. Connect the Ethernet cable
Plug the Ethernet cable to the device's LAN1 or LAN2 M12 connector. Check
that the corresponding LAN1 or LAN2 LED turns ON at that point.
4. Modifying the default IP address 192.168.1.253
From any PC of the network, run the multi-platform application ACKSYS
NDM application (found on the CD ROM).
Go directly to step 5 if the default IP address is compatible with your network.
Else, select the device and click on « Essential Config. » button. You can
configure the IP address or activate the DHCP client.

HARDWARE INSTALLATION

CONFIGURATION
-2-