Final Installation - Acksys RailBox Series Quick Installation Manual

6. Install the device
Place the device in an appropriate place. The device can be installed outdoor.
7. Install the antennas
Insure that their position and radiation pattern allow proper communication
with the peer Wi-Fi devices.
Ø
Specifically, insure that there are no obstacles between the
device and its peers ("line of sight" concept).
QUICKLY EVALUATE AP & BRIDGE MODES
Quickly evaluate the ACKSYS device in AP role
You need a second computer (PC2) with a working Wireless connection.
Set up the PC2 Wireless network interface according to the default
parameters of the ACKSYS AP device (802.11gn, SSID "acksys", no
security).
Quickly evaluate the ACKSYS device in client role
You need two ACKSYS devices, and a second computer (PC2) with a wired
LAN connection.
Set up the IP addresses according to the picture above and set the device
connected to PC2 to Client (infrastructure) role.
From each PC, start a command prompt and run the ping command to verify
the link.
From PC1: type ping 192.168.1.2, verify the answer returned by PC2
« Answer from 192.168.1.2... »
From PC 2: type ping 192.168.1.1, verify the answer returned by PC1
« Answer from 192.168.1.1... »
Notice: The State LED is flashing until the bridge connects to the AP.

FINAL INSTALLATION

-4-