Setting The Pc Audio; Setting The Sleep Timer - Toshiba 19AV500U Owner's Manual

H-Position:
•
Moves the picture left/right.
The adjustment range is -50~+50 (default value is 0).*
V-Position:
•
Moves the picture up/down.
The adjustment range is -10~+10 (default value is 0).*
Clock:
•
Helps to reduce noise and sharpen the picture.
The adjustment range is -10~+10 (default value is 0).*
Phase:
•
Helps to reduce noise and minimize periodic vertical
stripes on the screen.
The adjustment range is -15~+16 (default value is 0).*
* The default settings may vary depending on the input signal
format.

Setting the PC Audio

If the INPUT source is set to PC. The PC IN audio phone jack
is applied for PC IN when PC IN terminal is connecting with
an analog RGB cable. ( page 18)
Note: Because the PC Audio input is shared with HDMI.
If INPUT source is set to "HDMI ,"And the HDMI signal is
DVI format. This PC Audio input will apply for HDMI. (Also
see item 2 on page 11.)
Chapter 6: Using the TV's features

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set
length of time (maximum of 90 minutes).
To set the sleep timer using the remote control:
Press
the TV turns off. Repeatedly press
30-minute increments, to a maximum of 90 minutes.
To set the sleep timer using the on-screen menus:
1�
Press
2�
Highlight Sleep Timer.
3�
Press u or
increments.
Note: When a power failure occurs, the sleep timer setting
may be cleared.
To display the remaining sleep timer:
Press
using the on-screen menus.
To cancel the sleep timer:
Repeatedly press
on the remote control to set the length of time until
and open the Prefer menu.
to increase the time in 30-minute
Off30 Min60 Min90 MinOff
on the remote control or same as above process
until it is set to Off.
to increase the time in
1