Relationship Between Original And Paper; Acceptable Size Of Paper; Setting Rx Printing During Default Setup - Toshiba GD-1210 Operator's Manual

3 RECEIVING A FAX

Relationship between Original and Paper

Acceptable size of paper

Originals received by Fax can be printed on LD, LG, LT, ST, A3, B4, A4, B5 and A5 size paper,
and are printed in the printing range of each size of paper. No printing will occur in the margins
borders of the received originals as indicated by the gray borders on the figures below.
Set the paper in the drawers, the Large Capacity Feeder (optional) or Paper Feed Pedestal
(optional).
The paper set on the bypass tray is not available.
Drawers can be set for Fax only. See the [Operator's Manual for Basic Function].
If a specified drawer is set for Fax as a drawer by type, only the paper set in this drawer is
used when the equipment receives a Fax.
The paper that can be set in the drawer for Fax is LD, LG, LT, LT-R, A3, A4, A4-R and B4
sizes.
* If you want to set ST-R, A5-R, B5 or B5-R size paper in the drawer for Fax, ask your service technician.
5 mm

Setting RX printing during default setup

The received data are printed on paper which fits the incoming original size.
When the incoming original is shorter or the same length as the paper printing area, it is
printed in the original size.
When the incoming original is larger than the paper printing area, it is printed according to
the following priority: (Initial setting: Discard printing ON, Reduction printing ON) To change
the configuration to OFF, see
1. When originals are up to 10 mm larger than the printing area; the part of the originals that
exceeds the paper printing area is discarded.
2. When originals are at least 10 mm larger than the printing area; If the original can fit on a sin-
gle sheet of paper by reducing it to 90%* of its original size, it is reduced and printed on a
sheet of paper (Reduction printing). If the original cannot fit on a single sheet of paper, it is
printed on 2 sheets of paper.
* LG size originals are reduced to 75% to fit onto LT or LT-R paper.
3. Originals are printed on larger size paper.
62

Relationship between Original and Paper

5 mm
4 mm
5 mm
P.168 "Setting RX Printing".
5 mm
4 mm
5 mm 5 mm