KVH Industries TracVision R5 Installation Manual page 3

PLEASE READ!
Important Addendum to Your Product Manual
This addendum applies to the following TracVision antenna models:
R4, R5, R4SL, R5SL, and C3.
Power Supply and Grounding Kit
A 15-volt, 4-amp power supply and grounding kit are now included
with your TracVision system. Be sure to install these components as
explained in this addendum.
The power supply will ensure a stable power input to the TracVision
antenna. (Low power, fluctuating power, and RF noise can affect the
antenna's performance.) The grounding block will provide a single
ground point for the system and provide lightning protection.
Installing the Power Supply
Follow the steps below to install the supplied power supply.
a. Disconnect vehicle/vessel power. Test the circuit to
ensure that no power is present.
b. Connect the power supply's power and ground wires
to the switchplate's input power terminals, as shown in
the diagram on the following page.
c. Plug the power supply into vehicle/vessel AC power.
ECO #8286
Power Supply
TracVision R5SL/R4SL/R5/R4/C3
Addendum
Grounding Block
1