KVH Industries TracVision R5 Installation Manual page 26

Appendix C
24
User-defined Satellites
3. Type the following command (see the Key below)
then press Enter.
SATCONFIG,USERX,YYY,Z,D,L
Key: X
YYY= longitude (0-180)
Z
D
L
The main board has now been configured to recognize the user-
defined satellite. Next, you need to configure the RF board.
4. Type @DEGUGON then press Enter.
5. Type the following command (see the Key below)
then press Enter.
@SATCONFIG,X,N,F,S,C,ID,P,B,D
Key: @SATCONFIG = directs data to the RF board
X
N
F
S
C
ID = satellite network ID in hexadecimal format
P
B
D
= 1 or 2 (This represents the first or second
user-defined satellite. Your TracVision
system allows up to two user-defined
satellites.)
= E (East) or W (West)
= decoding type (1 = DSS-A,
2 = DSS-B, 3 = DVB)
= LNB polarization (C = circular, L = linear)
= satellite location A or B
= 98 User-defined slot 1 (USER1)
99 User-defined slot 2 (USER2)
= frequency in MHz (either 00000 or a
range from 10700 - 12700)
= satellite transponder symbol rate in Mbit/
second (01000 - 29999)
= FEC code
(e.g., 12, 23, 34, 56, 67, 78)
(0x####)
= LNB polarization (V - vertical,
H = horizontal, R = right, L = left)
= LNB down conversion frequency
(L = low, H = high, U = USA)
= decoding type (1 = DSS-A,
2 = DSS-B, 3 = DVB)
54-0359 Rev. A