KVH Industries TracVision R5 Installation Manual page 2

PLEASE READ!
Important Addendum to Your Product Manual
This addendum applies to the following TracVision antenna models:
R4, R5, R4SL, R5SL, and C3.
New Switchplate Design
The switchplate provided with
your system differs slightly from
the version shown in your manual.
Its input power connections are
simple power terminals rather than
a recessed terminal block.
To connect vehicle/vessel power to
this new switchplate, follow the
steps below.
a. Disconnect vehicle/vessel power. Test the circuit to
ensure that no power is present.
b. Crimp the supplied terminal connectors onto the
vehicle/vessel power wires (the DC power wires if
using an AC/DC power supply).
c. Carefully push the connectors onto the switchplate's
input power terminals as shown in the illustration
below.
All other installation and operation steps remain the same as described
in the manual.
ECO #8280
Vehicle/Vessel Power
Ground (Black)
+15 VDC (Red)
+
TracVision R4, R5, R4SL, R5SL, C3
Note: Strain-relieve the wires to
ensure a reliable connection.
–
Addendum
1