Installation - Televes T.OX Series Quick Installation Manual

Installation

1.
Install all units in the rack and connect them as shown in Figure 1.
Figure 1
2.
The audio and video input signals connect to the back of the
modules.
Figure 2
3.
If a network is available that provides IP addresses through DHCP,
connect the encoders to the network as shown in Figure 3. If such a
network is not available, then a computer will need to be connected
as shown in Figure 4.
Figure 3 - Rack with DHCP server.
4.
Power on the units.
Figure 4 - Rack without DHCP server.
5.
Connect the programmer to each unit and set a unique number in
the "# ID" field according to the order of installation of the units in
the rack.
6.
Connect the programmer to a unit, usually the first one, and read
the IP address.
Each unit can work as a master controller for the other units. All units
can be configured by connecting to only one.
NETWORK
with
DHCP server
7.
If a network was connected in Step 3 then proceed to step 8. If not,
set the address of you computer as follows:
NOTE: The default factory configuration of the units has an IP address in
8.
In your web browser, enter the IP address from Step 6 as the URL.
A login prompt will appear. By default the parameters are:
- # ID -
0001
Figure 5 - Set a # number different for each unit.
- NETWORK -
IP ADDRESS
001.001.
005.097
Figure 6 - Read the IP address of one unit.
IP value = 172.20.0.2
netmask = 255.0.0.0
gateway = 172.20.0.3
this range (it should be different for each unit). If a unit was ever
provided an address before, manually or through DHCP, this unique
address may no longer exist. Resetting to IP factory defaults, will
return the original unique private address though.
Login: encoder
Password: encoder
- # ID -
0006