Download Print this page
Toshiba SD-R2002 User Manual

Toshiba SD-R2002 User Manual

Cd-rw/dvd-rom combination mobile drive

Advertisement

TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-R2002
CD-RW/DVD-ROM COMBINATION MOBILE DRIVE
USER MANUAL

Advertisement

loading

Summary of Contents for Toshiba SD-R2002

  • Page 1 TOSHIBA AMERICA INFORMATION SYSTEMS STORAGE DEVICE DIVISION IRVINE, CALIFORNIA SD-R2002 CD-RW/DVD-ROM COMBINATION MOBILE DRIVE USER MANUAL...
  • Page 2: Table Of Contents

    CONTENTS Introduction...1 Setup ...3 Using the CD-RW/DVD-ROM Combo Drive ...4 Troubleshooting...6 Specifications ...7 Drive Connectors...10...
  • Page 3: Introduction

    INTRODUCTION – SD-R2002 General Features CD-RW disc write/rewrite at 1X, 2X and 4X 3-way Disc Eject (eject button, software, emergency eject hole) Average Access Time 120ms DVD-ROM 140ms Horizontal or Vertical Mount 2MByte Buffer Playback interchangeability for CD-ROM and DVD-ROM discs...
  • Page 4 Front Panel Figure 1.SD-R2002 CD-RW/DVD Combo Drive Front Panel Loading Load disc using tray. Tray Busy The LED lights green or amber when the drive is operating (LED is amber when drive is writing.) Indicator The Eject button is used to open the disc tray so you can install or remove a disc.
  • Page 5: Setup

    Toshiba's SD-R2002 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the ATAPI driver from our web site.
  • Page 6: Using The Cd-Rw/Dvd-Rom Combo Drive

    USING THE CD-RW/DVD-ROM Combo Drive – SD-R2002 Drive Operation Inserting Media To insert media perform the following steps: 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc.
  • Page 7 The SD-R2002 DVD-ROM/CD-RW drive supports the current RPC phase 2 industry specifications. This means that when the DVD-ROM drive ships from the factory it is set to the region for which the Operating System was intended.
  • Page 8: Troubleshooting

    TROUBLESHOOTING – SD-R2002 Problem Disc tray cannot be opened Drive is not recognized by system Drive is not recognized by system during Boot process, recognized Operating System (i.e. XP, Win2000, Win98, Win NT, etc.) BUSY Indicator LED flashes slowly BUSY Indicator LED is...
  • Page 9: Specifications

    SPECIFICATIONS –SD-R2002 General Interface: ATAPI Compatible CD-RW/DVD-ROM Standard - Write Write Formats: Disc at once, Track at once, session at once, Packet Write CD-R, CD-RW: Write Disc: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, CD-R, CD-RW: MIXED MODE CD, CD-I, CD-I BRIDGE (Photo-CD, Video-CD), Multi-...
  • Page 10 Performance Rotational Speed DVD-VIDEO CD-ROM CD-RW, Video-CD, CD-DA CD-R (write) CD-RW (write) Transfer Rate DVD-ROM DVD VIDEO CD-ROM Random Access Time Data Error Rate DVD-ROM CD-ROM Data Buffer Reliability MTBF Power ON Hours ON/OFF Cycles Number of Access Operating Duty Cycle MTTR 3,792rpm (2.5 - 6X) 1,377 –...
  • Page 11 DC Voltage and Current Requirements Physical Height Width Depth Weight Connectors IDE Interface Connector Regulatory The SD-R2002 DVD Writeable drive has been certified by the following regulatory agencies: • UL 1950 • CSA C22.2 No. 950 • TUV (EN60950I) • CE standard •...
  • Page 12: Drive Connectors

    Drive Connectors – SD-R2002 Figure 1.SD-R2002 DVD Writeable Drive Rear Panel – Connector ATAPI A 50-pin ATAPI interface connector is found at the rear of the SD-R2002 CD-RW/DVD- ROM Combo drive. Connecting cable should use Japan Aviation Electronics Industry Connector Limited KX14-50Series L or equivalent connector.