Toshiba SD-R1202 Installation Instructions Manual
Toshiba SD-R1202 Installation Instructions Manual

Toshiba SD-R1202 Installation Instructions Manual

Cd-rw/dvd-rom drive with vob instantcd/dvd and cyberlink powerdvd software
Hide thumbs Also See for SD-R1202:

Advertisement

TOSHIBA
Storage Device Division
CD-RW/DVD-ROM
DRIVE
SD-R1202

Installation Instructions

with VOB InstantCD/DVD
and
CyberLink PowerDVD
Software
TM
VERSION 2.0
MAY 2002

Advertisement

Table of Contents
loading

Summary of Contents for Toshiba SD-R1202

  • Page 1: Installation Instructions

    TOSHIBA Storage Device Division CD-RW/DVD-ROM DRIVE SD-R1202 Installation Instructions with VOB InstantCD/DVD CyberLink PowerDVD Software VERSION 2.0 MAY 2002...
  • Page 3 TOSHIBA AMERICA INFORMATION SYSTEMS, INC. STORAGE DEVICE DIVISION 9740 Irvine Blvd. Irvine, CA 92618 Contents of this manual are subject to change without prior notice. © 2002 TOSHIBA AMERICA INFORMATION SYSTEMS, INC. All rights reserved Printed in USA P/N 460023-B0...
  • Page 4 During the warranty period, Toshiba will, at its option, repair or replace defective parts with new parts or with reconditioned parts. Reconditioned parts will be equivalent or superior in performance to new parts.
  • Page 5 OPERATION OF THIS PRODUCT WILL BE UNINTERRUPTED OR ERROR FREE. IF THIS PRODUCT FAILS TO WORK AS WARRANTED ABOVE, YOUR SOLE AND EXCLU- SIVE REMEDY SHALL BE REPAIR OR REPLACEMENT. IN NO EVENT WILL TOSHIBA, ITS AFFILIATES OR SUPPLIERS BE LIABLE TO YOU OR ANY THIRD PARTY FOR ANY DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE PRODUCT.
  • Page 6: Table Of Contents

    Table of Contents Checking your Kit Packaging ... 1 System Requirements ... 1 Setting Jumpers ... 2 Placing CD-RW/DVD-ROM inside your computer ... 2 Connecting Cables ... 3 IDE BUS (data) Cable ... 3 Power Cable ... 4 Audio Cable ... 4 Completing Installation ...
  • Page 7: Checking Your Kit Packaging

    Congratulations on your purchase of a Toshiba CD-RW/DVD-ROM drive and Kit. The following information will help you in the simple installation of your new CD-RW/DVD-ROM drive. CHECKING YOUR KIT PACKAGING Please unpack your CD-RW/DVD-ROM kit, and assure that you have the follow-...
  • Page 8: Setting Jumpers

    The following steps must be performed to properly install your CD-RW/DVD- ROM. ! Set drive’s jumpers ! Connect audio cable ! Attach IDE BUS cable ! Connect power cable ! Mount CD-RW/DVD-ROM ! Install CyberLink PowerDVD ! Install VOB InstantCD/DVD software (used for recording CDs) SETTING JUMPERS The mode select jumpers are six (6) straight pins located on the rear of the CD-RW/ DVD-ROM.
  • Page 9: Connecting Cables

    2. If the CD-RW/DVD-ROM is replacing a CD-ROM, disconnect all connectors and remove the CD-ROM presently installed in your system. 3. Your Toshiba CD-RW/DVD-ROM can be placed in any free half-height drive slot at the front of your computer. (It can be mounted horizontally or vertically.) 4.
  • Page 10: Power Cable

    Connect secondary IDE BUS cable to CD-RW/DVD-ROM drive, assuring that pin 1 of the cable (side with red stripe) is connected to pin 1 on the drive. • If the CD-RW/DVD-ROM is the only drive connected on the secondary IDE BUS cable: connect drive to the last set of pins on IDE BUS cable.
  • Page 11: Completing Installation

    CD-RW/DVD-ROM to tip of screw). Replace the computer cover and all outer screws. ATAPI CD/DVD Software Driver: Toshiba’s CD-RW/DVD-ROM drives do not require any unique device drivers for Windows '95/'98/2000/Me/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '95/'98/2000/Me/XP/NT operating systems support all Toshiba ATAPI CD-RW, CD-ROM and DVD-ROM drives na- tively.
  • Page 12: Cyberlink Powerdvd

    CyberLink PowerDVD: *Before installing CyberLink software it is recommended you visit CyberLink’s website to check for any software updates (http://www.gocyberlink.com). CyberLink PowerDVD high-quality movies and karaoke into your multimedia PC. You can playback high resolution DVD titles or MPEG-2 files with superb MPEG-2 video and Dolby AC-3 audio quality.
  • Page 13: Cd-Rw/Dvd-Rom Front Panel

    Use a bar that is less than 1.5mm in diameter. Do not insert more than 50mm in depth as this may damage the drive. CD-RW/DVD-ROM FRONT PANEL The photo below illustrates the following features of the SD-R1202 CD-RW/ DVD-ROM front panel: " " " " "...
  • Page 14: Specifications

    DVD-ROM, DVD-R, DVD-RW, CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, CD-I, CD-I Bridge (Photo-CD, Video-CD), Multi-session CD (Photo-CD, CD- Extra, CD-R, CD-RW, Portfolio), CD-R, CD-RW http://www.sdd.toshiba.com 2,048 Byte/Block (mode 1) 2,336 Byte/Block (mode 2) CD-ROM, CD-R: 8,561rpm (13.8 - 40X) CD-RW: 3,281rpm (8.6 - 20X)
  • Page 16 460023-B0 P/N 460023-B0...

Table of Contents