Timer Programming - Toshiba D-R400 Owner's Manual

Use [K / L] to enter the date, then
3
press [B].

Timer Programming

Date Start
New Program
Date
JAN/02
L1/L2
L1
JAN/01
Daily
MON-SAT
MON-FRI
SAT
FRI
SUN
JAN/31
Use [K / L / { / B] or [the Number
4
buttons] to enter the start and end
time, then press [B].
New Program
Date
JAN/02 12 : 00AM
L1/L2
L1
Use [K / L] to select the appropriate
5
external input position (L1/L2) to
which your cable/satellite box is
connected, then press [B].
New Program
Date
JAN/02 12 : 00AM
L1/L2
L1
Use [K / L] to select a recording mode.
6
New Program
Date
JAN/02 12 : 00AM
L1/L2
L1
Refer to "Recording Mode" on page 34.
• You can check the remaining recordable space
of the disc when you select the recording mode.
Date Start
JAN/02 12 : 00AM
L1/L2 Mode
L1
38 38 EN EN
E7E7AUD_EN.indb 38 E7E7AUD_EN.indb 38
TIMER RECORDING
MON JAN/01 10:00AM
End L1/L2
Start End
- - : - - - - : - -
Mode
SP
SP 2 : 00
1/1
When pressing [L] at
the current date, the
date will change as
follows.
e.g.) January 1st
Start End
- - : - -
Mode
SP
SP 2 : 00
1/1
Start End
1 : 00AM
Mode
SP
SP 1 : 00
1/1
Start End
1 : 00AM
Mode
SP
SP 1 : 00
1/1
End
1 : 00AM
SP
SP 1 : 00
Auto recording mode select...
When "Auto" is selected as a recording mode, the unit
calculates how much time is available on the disc and
determines the appropriate recording mode to
complete recording the program.
New Program
Date Start
JAN/02 12 : 00AM
L1/L2 Mode
L1 Auto
• "Auto" is only available for one program in the timer
program list.
• The recording may be cut short, when the available
recording space of the disc is too limited.
7
Press [ENTER] when all items are
entered.
Your program setting will be stored.
• To set another program, repeat steps 2 to 7.
• To exit, press [TIMER PROG.] or [SETUP].
• When 2 or more programs are overlapped,
"Timer program overlapped" appears, and the
overlapped program will be displayed in blue.
To correct the timer program refer to
"Checking, canceling, or correcting the timer
programming information" on page 39.
8
Press [I/y ON/STANDBY] to set a
timer programming.
indicator will appear on the front panel display,
while this unit waits to make the recording.
End
1 : 00AM
Auto 1 : 00
1/1
2007/01/29 19:03:57 2007/01/29 19:03:57