Checking, Cancelling, Or Correcting The Timer Programming Information; If The Timer Programming Did Not Complete Correctly - Toshiba D-R160SB Owner's Manual

Checking, cancelling, or
correcting the timer programming
information
In the following example, No. 5 timer programming
overlaps on No. 1 and No. 6 timer programmes. In such
a case, you should correct the programme time to clear
the overlap.
Timer Programming
Date Start
1. 01/01 12:00
2. ---
3. ---
No.1 6
4. ---
5. 01/01 12:30
6. 01/01 13:45
7. ---
8. ---
1) Press [I/y ON/STANDBY] so that the
disappears from the front panel display.
2) Press [TIMER PROG.].
Timer Programming list will appear.
3) Check the information on the list to be edited.
4) To clear the timer programming, select the
desired programme using [K / L], then press
[CLEAR].
To correct the timer programming
1) Select the desired programme using [K / L], then
press [ENTER].
2) Correct the timer programming using
[K / L / { / B].
3) Press [ENTER] again.
5) Press [TIMER PROG.] to exit.
6) Press [I/y ON/STANDBY] to return to the timer
standby mode.
Note
• If a timer recording is proceeding, that programme is
highlighted in red. In such a case, you cannot select any
other programmes.
End CH Mode PDC
13:00 AV3 XP ON
Overlap
14:00 P02 SP OFF
21:00 P12 SEP OFF
icon
If the timer programming did not
complete correctly
The error number appears on the Timer Programming
list.
Timer Programming
Date Start End
* 01/01 12:57 1:57
2. ---
3. ---
4. ---
5. ---
6. ---
7. ---
8. ---
The error programme will be displayed in grey
with an asterisk and have an error number.
The error numbers indicate:
E1–E22, E37–E39: Recording error
E23–E24: Unrecordable disc
E25: • Copy prohibited programme
• Cannot record because of the NTSC / PAL-
60 signal is received.
E26–E28: Copy prohibited programme
E29: Disc protected
E30: Disc full
E31: Already recorded 99 titles (Video mode)
E32: Already recorded 99 titles (VR mode)
E33: Already recorded 999 chapters
E34: No space for Control Information
E35: PCA (Power Calibration Area) full
E36: Already finalised Video format disc
E40: • There are some unrecorded parts due the
overlapped timer programmes.
• Recording did not start at the start time.
E41: Power failure
E42: No disc
The error programme will be deleted once you
check the error in the programme list, or once you
cancel the timer-standby mode and re-enter it.
Press [CLEAR] to erase the selected programme.
CH Mode PDC
P08 E22 ON
EN 51