Timer Programming - Toshiba DKR40KU Owner's Manual

3
Use [K / L] to enter the date, then
press [B].
Date Start
JAN/02 - - : - -
L1/L2 Mode
L1
JAN/01
Daily
MON-SAT
MON-FRI
SAT
FRI
SUN
JAN/31
4
Use [K / L / { / B] or [the Number
buttons] to enter the start and end
time, then press [B].
Date Start
JAN/02 1 : 00AM
L1/L2 Mode
L1
• You cannot make a program whose recording
time exceeds 12 hours.
5
Use [K / L] to select an appropriate
external input (L1/L2) to which your
external tuner is connected, then
press [B].
Date Start
JAN/02 1 : 00AM
L1/L2 Mode
L1
6
Use [K / L] to select a recording
mode.
Date Start
JAN/02 1 : 00AM
L1/L2 Mode
L1
Refer to "Recording Mode" on page 33.
• You can check the remaining recordable space
of the disc when you select the recording
mode.
Date Start
JAN/02 1 : 00AM
L1/L2 Mode
L1
E7PCBUD_DKR40KU_EN.indd 39 E7PCBUD_DKR40KU_EN.indd 39
TIMER RECORDING
End
- - : - -
SP
SP 2 : 00
When pressing [L] at
the current date, the
date will change as
follows.
e.g.) January 1st
End
- - : - -
SP
SP 2 : 00
End
2 : 00AM
SP
SP 1 : 00
End
2 : 00AM
SP
SP 1 : 00
End
2 : 00AM
SP
SP 1 : 00
Auto recording mode select...
When "Auto" is selected as a recording mode, the unit
calculates how much time is available on the disc and
determines the appropriate recording mode to
complete recording the program.
Date Start
JAN/02 1 : 00AM
L1/L2 Mode
L1 Auto
• "Auto" is only available for one program in the timer
program list.
• The recording may be cut short, when the available
recording space of the disc is too limited.
7
Press [ENTER] when all items are
entered.
After displaying an instructive message for 10
seconds, timer program list will appear.
Press ON/STANDBY to Timer Standby mode.
Ensure the external source is turned to
the correct channel.

Timer Programming

JAN/ 2/09 1:00 AM L1 SP
SP (1:00) THU JAN/01 10:00AM
Date Start End
JAN/02 1:00AM 2:00AM
Your program setting is stored.
• To set another program, repeat steps 2 to 7.
• To exit, press [TIMER PROG.] or [SETUP].
• When 2 or more programs are overlapped,
"Timer program overlapped" appears, and the
overlapped program will be displayed in blue.
To correct the timer program refer to
"Checking, canceling, or correcting the timer
programming information" on page 40.
8
Press [I/y ON/STANDBY] to set a
timer programming.
will appear on the front panel display, while this
unit waits to make the recording.
CS DR
End
2 : 00AM
Auto 1 : 00
L1/L2
L1
CD
HDD
EN EN 39 39
2/5/2009 10:32:51 AM 2/5/2009 10:32:51 AM