Heater / Installation Kit
Quantity
Designation
1
Opel-specific heater delivery scope
1
Installation kit for Opel Vivaro starting with 2001 Diesel
1
Heater control
Foreword
This installation documentation applies to the vehicles Opel Vivaro Diesel - for validity, see page 2 -
from model year 2007 and later, assuming technical modifications to the vehicle do not affect installa-
tion, any liability claims excluded. Depending on the vehicle version and equipment, modifications may
be necessary during installation with respect to this installation documentation.
However, the stipulations in this "installation documentation" and "operating instructions" and the "in-
stallation instructions" for the Thermo Top E / C should be observed.
The corresponding rules of technology and any information from the vehicle manufacturer should be
observed during the installation work.
General Instructions
Installation should be carried out according to the general, standard rules of technology. Unless spec-
ified otherwise, fasten hoses, lines and wiring harnesses to original vehicle lines and wiring harnesses
using cable ties. Insulate loose wires and tie back.
Sharp edges must be provided with rub protection (cut-open fuel hose)!
Spray unfinished body areas, e.g. drilled holes, with anti-corrosion wax (Tectyl 100K, Order No. 111329).
While installing an IPCU, the corresponding settings must be checked or adjusted before the installa-
tion!
Special Tools
- Torque wrench for 2.0 - 10 Nm
- Hose clamping pliers
- Torx E5 nut
1311875B
Opel Vivaro
Order No.:
See Opel price list
9002568J
See Opel price list
3