Coolant Circuit, One Heat Exchanger - Webasto Thermo Top E Installation Documentation

Coolant Circuit, One Heat Exchanger

WARNING!
Any coolant running off should be collected using an appropriate container.
Route coolant hoses kink-free! Unless specified otherwise, always fasten using cable ties. Position
hose clamps and spring band clamps so that no other hose can be damaged.
The connection should be "inline" based on the following diagram:
Spring clip = 27 mm dia. All hose clamps
All connecting pipes = dia. 20x20. 1 = Black (sw) rubber isolator
3 = original vehicle spring clip
Ident. No.: 1311875B_EN
1
= 20-27 mm dia.!
(only 2.5 l dCi)
Status: 09.11.2012
Opel Vivaro
2
3
A
C
1
B
. 2 = Electrical auxiliary heater (option).
© Webasto Thermo & Comfort SE
Hose in-
stallation
diagram
14