Maintenance - Mac allister MJ10250XI Safety And Operation Instructions

MAINTENANCE

Always disconnect the device before performing
any adjustment or maintenance operation. If the
supply cord is damaged, it must be replaced by
the manufacturer or its service agent in order to
avoid a hazard.
Disconnect from the power supply immediately
if the supply cord is damaged.
1. Cleaning
- Keep the ventilation slots of the machine clean
to prevent overheating of the engine.
- Regularly clean the machine housing with a soft
cloth, preferably after each use.
- Keep the ventilation slots free from dust and
dirt.
- If the dirt does not come off use a soft cloth
moistened with soapy water.
- Never use solvents such as petrol, alcohol,
ammonia water, etc. These solvents may damage
the plastic parts.
WARNING: Make sure no water can reach the
inside of the power tool!
2. Lubrication
All motor bearings are permanently lubricated
at the factory, and do not require any additional
lubrication. Use graphite or silicone to lubricate
all mechanical parts of the table saw where
a pivot or threaded rod is present. Dry lubricants
do not hold sawdust like oil or grease.
3. Transportation
- When transporting the machine use only
transportation devices and do never use guards
for handling, lifting or transportation.
- During transportation the upper part of the saw
blade should be covered; for example by the
guard.
4. Storing
Store the machine, operating instructions and
where necessary the accessories in the original
packaging. In this way you will always have all
the information and parts ready to hand. Pack
the device well or use the original packaging in
order to avoid transit damage. Always keep the
machine in dry place.
23