Care And Maintenance - Mac allister MTSP800A Manual

GB
MTSP800A by MAC ALLISTER
IE
Saw blade replacement (Fig.18-19)
If the saw blade is damaged or deformed, please replace the saw blade.
Before replacing the saw blade, you must clean the flanges and use standard saw
blade which conform to EN847-1.
> Turn the bevel locking screw and set the saw blade to 0° and lock the bevel
locking screw.
> Unscrew the fixing screws (19) and remove bottom guard (6).
> Undo the nut (20) with spanner (18) on the nut itself and multi-spanner (17) on the
saw shaft to apply counter-pressure and remove nut (20) and outer flange.
> Take out the old blade and place one new blade (15) on arbor shaft. Make sure
saw blade teeth point down at the front side of saw table. Place outer flange and
arbor nut on arbor shaft and verify that large, flat surface of the outer flange faces
the saw blade and the saw blade (15) is firmly seated aganist the inner flange.
Tighten the nut (20) using spanner (18) and multi-spanner (17). Re-assemble the
bottom guard (6) using fixing screws (19).
19
20
Caution! Pull out the power plug.
Caution! Note the direction of rotation (see arrow on the
saw blade).
Fig.16

Care and maintenance

6
15
18
Loosen
17
Tighten
Fig.17
20