Mac allister MJ10250XI Safety And Operation Instructions page 4

– for tools provided with an isolating transformer: Never use the tool without
the transformer delivered with the tool or of the type as specified in these
instructions.
– Replacement of the plug or the supply cord shall always be carried out by the
manufacturer of the tool or his service organisation.
– Keep water clear off the electrical parts of the tool and away from persons in the
working area.
HEALTH ADVICE
WARNING!
produced. In some instances, depending on the materials you are working with,
this dust can be particularly harmful to you (e.g. lead from old gloss paint).
You are advised to consider the risks associated with the materials you are workingwith
and to reduce the risk of exposure. You should:
-- Work in a well-ventilated area.
-Work with approved safety equipment, such as those dust masks that are specially
designed to filter microscopic particles.
ADDITIONAL SAFETY INSTRUCTIONS FOR YOUR TABLE SAW
- Wear eye protection.
- Do not use the tool in presence of flammable liquids or gases.
- NEVER use the tool with an abrasive cut-off wheel installed.
- Check the blade carefully for cracks or damage before operation. Replace cracked
or damaged blade immediately.
- Use only saw blades recommended by the manufacturer and which conform
to EN847-1, and observe that the riving knife must not be thicker than the width of
the cut by the saw blade and not thinner than the body of the blade.
- Always use accessories recommended in this manual. Use of improper accessories
such as abrasive cut-off wheels may cause an injury.
- Select the correct saw blade for the material to be cut.
- Do not use saw blades manufactured from high speed steel.
- To reduce the emitted noise, always be sure that the blade is sharp and clean.
- Use correctly sharpened saw blades. Observe the maximum speed marked on the
saw blade.
- Clean the spindle, flanges (especially the installing surface) and hex nut before
installing the blade. Poor installation may cause vibration/wobbling or slippage of the
blade.
- Use saw-blade guard and riving knife for every operation for which it can be used,
including all through sawing operations. Always install the blade guard following
the instructions out-lined in this manual. Through sawing operations are those in
which the blade cuts completely through the workpiece as in ripping or cross cutting.
NEVER use the tool with a faulty blade guard or secure the blade guard with a rope,
string, etc. Any irregular operation of the blade guard should be corrected immediately.
- Immediately reattach the guard and riving knife after completing an operation which
requires removal of the guard.
- Do not cut metal objects such as nails and screws. Inspect for and remove all nails,
screws and other foreign material from the workpiece before operation.
When drilling, sanding, sawing or grinding, dust particles will be
4