Mac allister MJ10250XI Safety And Operation Instructions page 14

Fig. 17
Fig. 18
Fig. 19
Fig. 20
7. To assemble the blade gurad (Fig. 17-18)
WARNING: The saw blade guard must be in
position at all times to prevent contact with the
blade. It should lift up and onto the workpiece
when the workpiece is passed through the saw.
- Attach the blade guard over the riving knife so
that the hole in the guard and the hole in the
riving knife are aligned.
- Insert the screw M6 x45 and fit the flat washer
6 and hex nut M6.
- Tighten the hex nut sufficiently so that the guard
rests on the table top but will lift when the
workpiece is pushed into the table.
- Blade guard MUST be in place.
WARNING: The blade guard should return to its
rest position after the workpiece has been cut.
8. To assemble the rip fence to the table
(Fig. 19-21)
- Rip fence locking handle can be mounted on left
or right of the rip fence tube as Fig. 19 & 20.
- Loosen the locking handle, place the rip fence
on the saw table, keep the fence is level on the
table, then push down the rip fence locking
handle in order to lock the rip fence in position.
14
Fig. 21