Mac allister MJ10250XI Safety And Operation Instructions page 10

Stand legs (4pcs)
long top leg brackets (2pcs)
Short top leg brackets (2pcs)
Short bottom leg brackets (2pcs)
Long bottom leg brackets (2pcs)
Rubber feet (4pcs)
Screws M6 x 12 with nuts M6,
flat washers 6 and spring
washers 6 (16pcs)
Fig. 1
2
Fig. 2
2
3
Fig. 3
Warning: Before using your table saw,
read the instruction manual carefully.
Warning: Carefully remove the table
saw from the carton and remove the
protective polyfoam from around the
motor.
Warning: Do not connect to the power
supply before assembly, adjustment
and maintenance.
ASSEMBLY OF THE TABLE SAW
1. To assemble the leg stand (Fig. 1-5)
- Unpack all parts, and group them by type and
size. Refer to Fig. 1 for correct quantities.
- Attach one long top leg bracket (1) to the top of
one leg (2) using a screw, flat washer, spring
washer and hex nut. (Fig. 2)
NOTE: Do not tighten the bolts until the stand is
properly aligned (see step #8).
- Attach other end of the long top leg bracket (1)
to top of another leg (2) using using a screw,
flat washer, spring washer and hex nut.
- Attach one long bottom leg bracket (3) to the
1
centre of each leg (2) using a screw, flat washer,
spring washer and hex nut. This completes the
front frame section. (Fig. 3)
- Assemble the rear frame section in exactly the
same manner.
- Join the front and rear frame assemblies to the
two short upper supports (4) and two short
bottom supports (5) using a screw, flat washer,
spring washer and hex nut. (Fig. 4)
1
2
10
3
2
4
1
3
5
3
2
Fig. 4
1
4
2
5
2