Mac allister MJ10250XI Safety And Operation Instructions page 22

90° Set screw 90° Set screw
45° Set screw 45° Set screw
Fig. 32
Fig. 33
Triangle square Triangle square
Fig. 34
Square Square
ADJUSTMENT
1. Adjusting the bevel stops (Fig. 32-34)
This saw has positive stops that will quickly
position the saw blade at 90° or 45° to the table.
The angle settings of the saw have been set at
the factory and, unless damaged in shipping,
should not require setting during assembly. After
extensive use, it may need to be checked.
Make adjustments only if necessary.
- Unplug the saw.
- Remove the blade guard.
- Raise the blade to the maximum height by
turning the high adjusting knob counterclockwise.
- Using a square, set the blade to exactly 90°.
- If the blade stops bevelling before it gets to 90°,
loosen the stop screw (located on the left under
the table) (Fig. 32) with the hex key (not included),
and then adjust it to 90°.
- With the blade set at 90°, slowly turn the 90°-
stop set screw until you feel resistance. Bevel the
blade away from 90° a little, and then back to the
stop.
- Re-measure the angle, and repeat the stop
adjustment as necessary until the blade stops at
90°.
- Set the 45° stop in the same way. The set screw
for the 45° stop is located on the right under table.
22