Mac allister MJ10250XI Safety And Operation Instructions page 13

Push stick hold (2pcs)
Screws (4pcs)
Fig. 14
1 1
Fig. 15
Riving knife with screw M6 x 45
flat washer 6 and hex nut M6 (1pc)
3 3
Fig. 16
5. To assemble the push stick hold
(Fig. 14)
There is a push stick hold on the left side of the
machine. You can connect the push stick hold
with four screws supplied and you can put the
push stick on the hold when you do not use it.
6. To assemble the riving knife (Fig. 15-16)
- Loosen the eight cross-screws (1) with the
screwdriver and remove the table insert. (Fig. 15)
- Loosen the nut on the riving knife with 10mm
spanner (not supplied), remove the screw M6 x 45,
flat washer 6 and hex nut M6.
- Loosen the blade bevel-locking handle and tilt
the bevel adjusting handwheel to 90° and turn
height adjusting knob to raise the blade to its
highest position. Tighten the blade bevel-locking
handle.
- Loosen the tri-wing knob (2) to insert the riving
knife (3) and push it down, when you hear a "click"
the pin is locked into the hole on the riving knife.
- Tighten the tri-wing knob (2).
- Reinstall the table insert.
2 2
13