Mac allister MJ10250XI Safety And Operation Instructions page 11

Fig. 5
Hex bolts M6 x 25 (4pcs)
Flat washers 6 (4pcs)
Hex nuts M6 (4pcs)
Fig. 6
Extension tables (2pcs)
Supporting bars (4pcs)
Hex bolts M6 x 16 (14pcs)
Flat washers 6 (18pcs)
Hex nuts M6 (14pcs)
Spring washers (10pcs)
Fig. 6
- Insert the rubber foot (6) into the bottom of
each leg. (Fig. 5)
- Place the stand on a level surface, and adjust it
so that all of the legs are contacting the floor
and are at similar angles to the floor. Tighten
all of the screws.
NOTE: The stand should not rock after all of the
bolts have been tightened.
6
2. Attach the table saw to the stand (Fig. 6)
- Place the stand on a level surface and level the
stand to the floor.
- Place the table saw on top of the stand, aliging
the holes in the base with the holes in the stand.
- Insert four hex bolts M6 x 25 (1) along with flat
washers 6 (2) into the aligned holes.
- Tighten all four hex nuts M6 (3) and hex bolts (1).
NOTE: Do not over-tighten the bolts that hold
the saw to the stand. Doing so will damage the
saw base.
3. To
(Fig. 6-10)
1
- Attached the left extension table to the main
2
table with three flat washers 6, three spring
washers 6, three hex nuts M6 and three hex bolts
3
M6 x 16 (see Fig. 6-8).
assemble
Fig. 7
Fig. 8
11
the extension
1 1
tables