IGMG-P83244GC+-D4G
User Manual
DIN-rail Measurement (Unit = mm)
Follow the steps below to install the device to a rack.
Step 1: Screw the two pieces of wall-mount kits onto both ends of the rear panel of the switch.
A total of six screws are required, as shown below.
Step 2: Use the switch, with wall mount plates attached, as a guide to mark the correct
locations of the four screws.
Step 3: Insert a screw through the cross-shaped aperture on the plate, and then slide the
switch downwards. Tighten the screw for added stability.
ORing Industrial Networking Corp.
6