Table of Contents
Advertisement
Bosch Recording Station Appliance
1.
2.
3.
4.
2.4.5
Installing the Chassis into a Telco rack
To install the chassis into a Telco type rack, use two L-shaped brackets on either side of the
chassis (four total). First, determine how far follow the server will extend out the front of the
rack. Larger chassis should be positioned to balance the weight between front and back. If a
bezel is included on your server, remove it. Then attach the two front brackets to each side of
the chassis, then the two rear brackets positioned with just enough space to accommodate
the width of the telco rack. Finish by sliding the chassis into the rack and tightening the
brackets to the rack.
Bosch Security Systems
Confirm that chassis includes the inner rails (A) and rail extensions (B). Also, confirm
that the outer rails (C) are installed on the rack.
Line chassis rails (A and B) with the front of the rack rails (C).
Slide the chassis rails into the rack rails, keeping the pressure even on both sides (you
may have to depress the locking tabs when inserting). When the server has been pushed
completely into the rack, you should hear the locking tabs "click" into the locked position.
(Optional) Insert and tighten the thumbscrews that hold the front of the server to the
rack.
Quick Installation Guide
System Hardware Setup | en
XMD-0041-VV002 | V1 | 2011.10
17
Advertisement
Table of Contents
