Raven Viper Pro Update Manual page 9

Hide thumbs Also See for Viper Pro:

10.When the update is complete, the following prompt will be displayed.

11.Touch the "OK" button and then select the "Start" button and "Shut Down" from

the displayed menu.

12.Select "Restart" to reboot the Viper Pro field computer.

Note:

If the Viper Pro fails to restart, remove the main interface cable connector

for at least 10 seconds. Reconnect the cable and press the power button to

restart the Viper Pro.

13.Start the Viper Pro management system.

14.From the main Viper Pro screen, select the Menu button in the lower, right

corner of the display and select About.

15.Verify that CAN firmware version 22 is shown. If so, the firmware update has

been successful.

16.Check the software version displayed on the screen.

a. If the software version is 3.5.0.21 or newer, no software update is

necessary to utilize the automatic power down feature. Continue with the

following steps to return the field computer to operational status.

b. If the software version is lower than 3.5.0.21, a software update is

required before the automatic power down feature may be used. Continue

with the following steps and then complete the "Viper Pro Software

Update" section on page 9.

17.Shutdown the Raven Viper Pro field computer.

18.Reconnect the Raven CAN switch box or Switch Pro.

19.Reconnect the 4-pin 'CAN' connectors located below the pump switch

instrument panel.

20.Carefully replace the instrument panel.