Advertisement
N5242-80006 for N5242A models).
Step 21.
Install the Front Panel Jumper Cables
For instructions on installing the W30 front panel jumpers (N5222-20091), click the Chapter 7 bookmark
"Removing and Replacing the Front Panel Assembly" in the PDF Service Guide
Step 22.
Position the Cables and Wires to Prevent Pinching
On the top side of the PNA, carefully position the grey flex cables so they can't be pinched between the covers
and the rails.
On the bottom side of the PNA, carefully fold or push down the ribbon cables and wires so they can't be
pinched between the hardware and the outer cover. Ribbon cables and wires must never be positioned on top
of hardware.
Step 23.
Reinstall the Inner Cover
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the PDF Service Guide
Step 24.
Reinstall the Outer Cover
For instructions, click the Chapter 7 bookmark "Removing the Covers" in the PDF Service Guide
Step 25.
Enable Option 400
Procedure Requirements
• The analyzer must be powered up and operating to perform this procedure.
• The Network Analyzer program must be running.
• Obtain a license key for installation of this upgrade by following the instructions on the supplied Option
Entitlement Certificate.
Option Enable Procedure
1. To start the option enable utility, press UTILITY
option enable dialog box will appear.
2. Click the arrow in the Select Desired Option box. A list of available options will appear.
3. In the Select Desired Option list, click P04 - 4-Ports.
4. Using the keyboard, enter the license key in the box provided. The license key is printed on the the license
message you received from Keysight. Enter this key exactly as it is printed on the message.
5. Click Enable.
6. Click Yes in answer to the displayed question in the Restart Analyzer? box.
7. When the installation is complete, click Exit.
Option Verification Procedure
Installation Note N5242-90115
Service
System
, then
1
.
1
.
1
.
Option Enable
, then
. An
27
Advertisement
