Advertisement
Figure 9
Second Source Boards Installation, Part 1
Install Cable on Source 2 Synthesizer Board
Install gray cable W67 (N5242-60030) to connector J5 of the Source 2 Synthesizer board. The loose end of the
cable will be connected on the A10 frequency reference board (J7) after the Source 2 Synthesizer board has
been installed in the analyzer.
Install the Second Source Boards into the Analyzer
Refer to
Figure 9-2
for this part of this step of the procedure. New parts are listed in
Table 1 on page
8.
1. Install the A8 26.5 GHz source 2 board (5087-7307) and the A13 13.5 GHz source 2 synthesizer board (N5240-
22
Installation Note N5242-90115
Advertisement
