Advertisement
Step 14.
Install the Coupler Plate Assembly to the Deck
Follow the four instructions shown in
Figure 8
Coupler Plate Assembly Installation
Step 15.
Install the Second Source Boards
Install Cables on Source 2 Board
Refer to
Figure 9
of this document for this part of this step. New parts are listed in
document.
1. Attach new cables W5 (N5222-20062) and W7 (N5222-20063) to the A8 26.5 GHz source 2 board as shown.
Make sure that both cables are parallel to the A8 26.5 GHz source board as shown in the END VIEW. Cable
W5 is the longer of the two cables.
2. Use a 5/16-in torque wrench set to 10 in-lbs to tighten the cable connectors.
Installation Note N5242-90115
Figure
8.
Table 1 on page 8
of this
21
Advertisement
