S&P CTB ECOWATT Installation Manual. Instructions For Use page 49

MAX-OUTPUT
< 100% OK
OK OK
SETUP LEVEL 2?
< NO YES
OK OK
ENTER PASSWORD:
1 1 1 OK
OK OK
CHANGE PASSWORD
YES NO
OK OK
MOTOR TYPE
< EC OK
OK OK
S1-ALARM
< 90% OK
OK OK
S2-ALARM
< 90% OK
OK OK
Press or to manually modify the maximum
output parameter to the motor
Access to advanced configuration parameters
Enter the password
Default: 1 1 1
It is possible to assign a new password to your device
(channel)
No modify
Press or to modify manually this parameter.
This value allows you to send an alarm message when
measured by sensor IN1 value reaches a percentage of
measuring range
Press or to modify manually this parameter.
This value allows you to send an alarm message when
measured by sensor IN2 value reaches a percentage of
measuring range
49