Looking After And Servicing The Wrk; Accessories; Disposal; Warranty - Weller WRK Operating Instructions Manual

8-8
1. Position the pick-up over the workpiece (see 6.1) and prepare
desoldering (see 6.2).
2. Feed the hot-air tool from the side through the designated nozzle
opening up to the workpiece and actuate the tool until the
workpiece is detached and raised by the pick-up fitting.
The marker ring is now in the upper position.
3. Remove the hot-air tool and switch off.
4. Position the pick-up together with the nozzle and the workpiece
subjected to suction on the desired set-down surface.
5. Carefully press the pick-up downwards and switch off the
vacuum.
The workpiece is set down on the set-down surface.
Note You can also work with the HAP 200 without a reflow nozzle, e.g. in
the case of workpieces > 30 mm.

7 Looking after and servicing the WRK

Clean the WRK on a regular basis with a mild special-steel cleaning
agent.

8 Accessories

005 15 15 499 WRK holder
005 87 617 30 Desoldering set 33x33/24x24 with pick-up
005 87 617 31 Desoldering set 27x27/20x20 with pick-up
005 87 617 32 Desoldering set 18/15.5/12.5/10 with pick-up
005 87 617 39 WRK ACCESSORY KIT
005 87 617 40 WRK VACUUM PICK-UP SET

9 Disposal

Dispose of replaced equipment parts, filters or old devices in
accordance with the rules and regulations applicable in your country.

10 Warranty

Claims by the buyer for physical defects are time-barred after a
period of one year from delivery to the buyer. This does not apply to
claims by the buyer for indemnification in accordance with
§§ 478, 479 BGB (German Federal Law Gazette).
We shall only be liable arising from a warranty furnished by us if the
quality or durability warranty has been furnished by use in writing
and using the term "Warranty".
Subject to technical alterations and amendments!
See the updated operating instructions at www.weller-tools.com.
WRK