Table of Contents
Advertisement
PRODUCT INSTALLATION INSTRUCTIONS Dispensing Towers
DRAFT ARM AND TEE TOWER INSTRUCTIONS
Draft Arm Preparation
Remove backing from foam gasket #57355-1. Attach the gasket to the bottom flange of the
draft arm, ensuring the four mounting holes are aligned.
Tee Tower Preparation
There is no preparation needed for Tee Tower style dispensing heads.
Mounting Draft Arms or Tee Towers to a Cabinet Top
Note: If you are mounting the tower to a counter top instead of the cabinet top, please refer to the section titled
Mounting Draft Arms or Tee Towers to a Counter Top on the following page.
1. Most cabinets come with pre-drilled hole configurations in the cabinet top for mounting
dispensing towers and drainers. However, if the holes need to be drilled during field instal-
lation, templates are available at
downloads/tower-and-drip-pan-templates/.
2. Factory-provided tapping holes will have a wood block embedded in the cabinet top for
additional support. It is recommended that you drill 3/32" pilot holes into the wood block for
the four mounting holes on the tower flange. Remove the protective film paper from the area
where the tower will be installed.
1
3. Attach the dispensing tower to the cabinet top using a flathead screwdriver. To prevent
accidental scratches or gouges, cover the tower flange and cabinet top while mounting the
tower. The tower should be sealed to the cabinet top with a food grade RTV silicone.
3
Mounting Draft Arms or Tee Towers to a Counter Top
1. A PVC tube, (Part #67562), is included in the tapping kit. This will be used as an air shaft when mounting to a
counter top. Please refer to Diagram 7 in the Appendix for detail on how to mount a Draft Arm or Tee Tower to a
counter top. The tower should be sealed to the cabinet top with a food grade RTV silicone.
PERLICK CORPORATION 8300 W. Good Hope Road, Milwaukee, WI 53223 • 800.558.5592 • perlick.com
DISPENSING TOWERS
DRAFT ARMS, 2-6 FAUCET TEE TOWERS, LUCKY AND PANTHER TOWERS
www.perlick.com/bar-beverage-equipment/specifications-
10
Advertisement
Table of Contents
Need help?
Do you have a question about the Draft Arm and is the answer not in the manual?
Questions and answers