National Instruments FP-AO-200 Operating Instructions Manual page 10

1
Monotonicity
Offset temperature coefficient .......... 50 nA/°C
Gain temperature coefficient ............ 40 ppm/°C
Dynamic Characteristics
Max conversion rate.......................... 200 updates/s
Slew rate ........................................... 0.4 mA/µs
Physical Characteristics
Indicators .......................................... Green POWER and
Weight
FP-AO-200 ................................. 140 g (4.8 oz)
cFP-AO-200 ............................... 110 g (3.7 oz)
Power Requirements
Power from network module ............ 350 mW
Isolation Voltage
Channel-to-channel isolation ............ No isolation between
Transient overvoltage........................ 2,300 V
Environmental
FieldPoint modules are intended for indoor use only. For outdoor
use, FieldPoint modules must be mounted inside a sealed
enclosure.
Operating temperature ...................... –40 to 70 °C
Storage temperature .......................... –55 to 100 °C
Humidity ........................................... 10 to 90% RH,
Maximum altitude............................. 2,000 m
Pollution Degree .............................. 2
1
A characteristic of a DAC in which the analog output always increases as the value
of the digital code input to it increases.
FP-AO-200 and cFP-AO-200
................................... Guaranteed over operating
temperature range
READY indicators, 8 red
open-loop indicators
channels
rms
noncondensing
10 ni.com