Operation; Enabling And Selecting Parameters - Samson 3731-5 Mounting And Operating Instructions
Electropneumatic ex d positioner with foundation fieldbus communication
Hide thumbs
Also See for 3731-5:
- Mounting and operating instructions (92 pages) ,
- Operating instructions manual (132 pages)
Table of Contents
Advertisement
Operation
8 Operation
WARNING
!
Risk of injury by exposed moving parts on the positioner, actuator or valve.
Do not touch or block exposed moving parts during operation.
8.1 Enabling and selecting parameters
All codes and their meaning and default settings are listed in the code list in section 12.3 on
page 81 onwards.
Codes which are marked with an asterisk must be enabled with Code 3 before the associat-
ed parameters can be configured as described below.
1. Turn
until Code 3 appears (reading:
OFF).
2. Press
, the code number 3 blinks.
3. Turn
until ON appears.
4. Press
to confirm (reading:
You can now configure codes one after the
other:
Î Turn
to select the required code.
Î Press
to activate the selected code. The
code blinks.
Î Turn
to select the setting.
Î Press
to confirm the selected setting.
Note
If no settings are entered within 120 seconds, the enabled configuration function becomes in-
valid and the display returns to Code 0.
72
).
Code 3:
Configuration not
enabled
Configuration enabled
EB 8387-5 EN
Advertisement
Table of Contents
