Table of Contents
Advertisement
Using the LionChief remote control continued
Locate the Remote / Track switch on the bottom of the tender and place it in the Remote
3
position. Place the sound switch in the ON position. See figure 3 on page 6.
Place your train set on the track ensuring all wheels are on the rails.
4
Power up your layout. Plug in your wall-pack power sup-
5
ply and connect it to the track. If you are using a conven-
tional DC power supply, turn the power up to around 14
Volts. You will hear a chime sound from the locomotive
indicating that it is looking for a signal from a remote or
Bluetooth ® device.
Turn on the LionChief Remote using the toggle switch on the side of
6
the remote.
The remote will automatically pair with the locomotive. Once acquired, the chime
7
sounds will stop and you will hear the locomotive sounds.
Note!
Your train is ready to run!
8
Coupling
W
hen coupling your cars, at least one of
the mating couplers must be open as
shown at the left in Figure 5. Push the cars
toward each other until they lock together.
Note!
Keep in mind that it's easier to
couple cars on a straight section
of track.
The locomotive can only pair with one device at a time. If you have already
paired the locomotive with another Bluetooth ® device (the Lionel Universal
Remote or a phone or tablet using the LionChief app) then your locomotive
will not pair with the set remote until released from the other device.
Figure 5. Coupler operation
8
Advertisement
Table of Contents
