Table of Contents
Advertisement
Using a conventional transformer
Y
ou can control your set with a conventional DC power supply directly without the use of the
LionChief Remote.
Due to the power demands of the sound system, you will not have sounds when run-
Note!
ning with your transformer. Your locomotive will also not start moving until you
have applied approximately 7 to 8 volts to the track and will have a different speed
range than non-sound equipped locomotives. To get the full sound features from the
locomotive, power up your transformer to full power and use the LionChief Remote to
control the locomotive's speed, direction and sound features. See page 9 for complete
remote operating instructions.
We recommend a 20 Watt transformer or larger for best operation. Using a less pow-
Note!
erful transformer will not provide optimal performance. Do not exceed 16 Volts or
damage to the electronics may occur.
Connect the locomotive and tender. Plug the six-pin
1
connector into the bottom of the locomotive. Connect
the tender drawbar using the hole of your choice. We
recommend using the shortened drawbar position
only for larger radius curves.
Locate the Remote / Track switch on the bottom of the tender and place it in the TRACK
2
position. See figure 3 on page 6 for the location of the switch.
Place the set on the track ensuring all wheels are on the rails.
3
Power up your layout. Use your transformer speed dial and direction switch to control
4
your locomotive.
Note!
The locomotive must be brought to a stop before changing direction.
23
Advertisement
Table of Contents
