Table of Contents
Advertisement
Controlling your set with DCC
Y
our set can also be controlled by a DCC system. Refer to your system user manual for set up of
your DCC power.
Connect the locomotive and tender. Plug the six-pin
1
connector into the bottom of the locomotive. Connect
the tender drawbar using the hole of your choice. We
recommend using the shortened drawbar position
only for larger radius curves.
Locate the Remote / Track switch on the bottom of the tender and place it in the TRACK
2
position. See figure 3 on page 6 for the location of the switch.
Place the set on the track ensuring all wheels are on the rails.
3
Power up your layout. The locomotive is preset to address 3 from the factory. Program
4
your locomotive address and operate it per your system's instructions.
Sound Keys
Use the following short keys to access the locomotive features:
F0:
Headlight
F1:
Bell
F2:
Whistle
F3:
Turns on sounds
F5:
Announcements
F8:
Turns off sounds
24
Advertisement
Table of Contents
