Table of Contents
Advertisement
Compatibility & limitations continued
CV29 supports the following (default is 18 decimal, 12 hex)
Bit 0 = Locomotive Direction: "0" = normal, "1" = reversed. This bit controls the
Bit 1 = FL location: set to "0" in bit 4 to allow Speed and Direction instructions control the
Bit 2 = Power Source Conversion: Set to"0" = DCC Capable Only
Bit 3 = Bi-Directional Communications: Set to "0" = single direction
Bit 4 = Speed Table: "0" allows speed table set by configuration variables #2,#5, and #6, "1"
Bit 5 = "0" = one byte addressing, "1" = two byte addressing (also known as extended addressing).
Both modes are supported.
Bit 6 = Reserved for future use
Bit 7 = Accessory Decoder: "0" = Multifunction Decoder, "1" = Accessory Decoder, this bit is
locomotive's forward and backward direction in DCC mode
only.
FL, "1" = bit 4 in function group one instruction controls FL. The rec-
ommended setting is"1".
= Speed Table set by configuration variables #66-#95. Must set to "1", and
is only active in Speed Step 14 and 28 modes. The speed step profile in 128
speed step mode is internally controlled.
set to "0".
communication.
29
Advertisement
Table of Contents
