Ignition Switch - Can-Am SPYDER RT Series 2020 Original Instructions Manual

1) Ignition Switch

rmo2008-001-002_a
IGNITION SWITCH
1. OFF
2. ON
3. Front storage compartment opening
4. Seat opening
5. Handlebar and glove box locking position
The ignition switch is located just below
the center of the handlebar.
NOTICE If the key does not turn eas-
ily, do not force it.
reinsert.
WARNING
If you turn the ignition switch to
OFF, it shuts off the engine and all
the electrical systems including the
VSS and DPS. If you do this while
the vehicle is moving, you could
lose control and crash.
Two keys are provided with your vehi-
cle. Each key contains a transponder
chip specifically pre-programmed that
is read via radio frequency by the im-
mobilizer system to allow starting the
engine. The keys do not contain batter-
ies. Do not take the key apart. If the im-
mobilizer system cannot read the key,
the engine will not start. For the con-
ditions that can lead to the immobilizer
system failing to read the key, refer to
the
DIAGNOSTIC GUIDELINES
Pull it out and
. Store the
spare key in a safe place because you
must have your spare key to have an-
other one made by an authorized Can-
Am On-Road dealer.
Ignition Function
OFF
The key can be inserted or removed in
this position.
In the OFF position, the electrical sys-
tem of the vehicle is disabled.
The engine is shut down by turning the
ignition switch to the OFF position.
ON
When the key is turned to this position,
the electrical system of the vehicle is
activated.
The gauge should wake-up.
The vehicle lights are turned on.
The engine can be started.
Locking the Handlebar/Glove Box
To lock the steering mechanism and
the glove box:
1. Insert key in ignition switch.
2. Rotate the handlebar all the way to
the right or to the left.
3. Turn the key 1/4 turn counterclock-
wise to the steering lock position
then remove key.
219002072-206
KEY POSITION TO LOCK HANDLEBAR
SECONDARY CONTROLS
19